Grounding issues

[LONNIE]

Hello ,
i just built a kneckset gutair and installed 2 splitcoil humbuckers and
a baggs x- bridge non trem.
The magnetic pickups work but i cannot get anything but a loud buzz when i blend or
switch to the acoustic side. Have double checked wiring , obviously a grounding issue i am missing!!
Any help would be appreciated.

[Caleb_Elling]

Hi Lonnie,
I would recommend checking the wiring at the summing board for the X-Bridge. If any of those pads are connected to ground, the whole bridge would be shorted to ground and not pass any signal.

[LONNIE]

Great thankyou i will ck that and reply.
By sthe summing board you mean under the bridge it self??

[Caleb_Elling]

It's where the leads from the bridge are summed into a single wire lead.

[LONNIE]

Great thanks

[LONNIE]

Good morning,
i checked my bridge last night and the solder tab pulled loose,
Is there a way to reattatch this ??
It didnt seem to take solder

[Caleb_Elling]

Did the solder pull off of the bridge, or the summing board?