Announcement

Collapse
No announcement yet.

Grounding issues

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Caleb_Elling
    replied
    Did the solder pull off of the bridge, or the summing board?

    Leave a comment:


  • LONNIE
    replied
    Good morning,
    i checked my bridge last night and the solder tab pulled loose,
    Is there a way to reattatch this ??
    It didnt seem to take solder

    Leave a comment:


  • LONNIE
    replied
    Great thanks

    Leave a comment:


  • Caleb_Elling
    replied
    It's where the leads from the bridge are summed into a single wire lead.

    Leave a comment:


  • LONNIE
    replied
    Great thankyou i will ck that and reply.
    By sthe summing board you mean under the bridge it self??

    Leave a comment:


  • Caleb_Elling
    replied
    Hi Lonnie,
    I would recommend checking the wiring at the summing board for the X-Bridge. If any of those pads are connected to ground, the whole bridge would be shorted to ground and not pass any signal.

    Leave a comment:


  • LONNIE
    started a topic Grounding issues

    Grounding issues

    Hello ,
    i just built a kneckset gutair and installed 2 splitcoil humbuckers and
    a baggs x- bridge non trem.
    The magnetic pickups work but i cannot get anything but a loud buzz when i blend or
    switch to the acoustic side. Have double checked wiring , obviously a grounding issue i am missing!!
    Any help would be appreciated.
Working...
X