Hello,
I am currently playing one of the new Gibson J-35 reissues. It has a factory installed Baggs Element pickup. I want to combine it with a Baggs M1 passive sound hole pickup and run them both to a stereo output jack. I plan to run a single TRS stereo to dual mono Y-cable to a Radial Tonebone PZ-Pre where I will blend the two pickups. I want to keep the Element's volume wheel attached below the sound hole so I that I still can control it separately. I was told that this was doable and that it's a pretty standard install. When I dropped it off with my luthier/repair guy this morning he asked me if I had a wiring diagram. I've looked on the Baggs website and could not find anything. Is there anyplace that I could access this? Or, at the very least some detailed instruction that I can pass along to him to make sure this is done correctly.
Thanks!
I am currently playing one of the new Gibson J-35 reissues. It has a factory installed Baggs Element pickup. I want to combine it with a Baggs M1 passive sound hole pickup and run them both to a stereo output jack. I plan to run a single TRS stereo to dual mono Y-cable to a Radial Tonebone PZ-Pre where I will blend the two pickups. I want to keep the Element's volume wheel attached below the sound hole so I that I still can control it separately. I was told that this was doable and that it's a pretty standard install. When I dropped it off with my luthier/repair guy this morning he asked me if I had a wiring diagram. I've looked on the Baggs website and could not find anything. Is there anyplace that I could access this? Or, at the very least some detailed instruction that I can pass along to him to make sure this is done correctly.
Thanks!
Comment